Build – Move – Elements

nMoving the Element(s) by Entering Values

To move the element(s) by specifying how much they must be moved, follow the procedure given below.

Note

If Build – Move – Elements mode was activated using the shortcut key, the element(s) cannot be moved by this method.

Operating Procedure The following steps must be carried out in Build – Move – Elements mode.

1 Click the right mouse button.

The [Build-Move-Elements] dialog box will ap- pear.

Chapter 2

2 Enter the desired amount of movement for X, Y and Z.

The amount can be entered for all the axes at the same time.

Build

Menu

3 Click the [Apply] button.

The selected element(s) will move according to the values entered.

4 Click the [OK] button.

The [Build-Move-Points] dialog box will close, movement of the point(s) will be confirmed, and the Build-Move-Pointsmode will be canceled.

9i

910

900

700

300

If you change a value(s) and click the [Apply] button, the element(s) will move again according to the new value(s).

New values will not be added to the previous values. They are absolute values from the original position.

Clicking the [Cancel] button will cancel all the operations that have been performed since the dialog box was opened.

190