File – Import – Digitizer – Step Scan (When VIVID 900/910 is Selected)

8 Inton.the [General] tab, click the [Go] but-

The [File-Import-Digitizer-Step Scan-Convert] dialog box will appear.

Chapter 2

File

Menu

Note

If no chart data exists or the existing chart data does not match the measurement conditions, the following error messages will appear.

9 Enter the desired element name, and set parameters.

Note

The element name must consist of up to 31 alphanumeric characters.

910

900

•Select the desired rate from “1/1”, “1/4”, “1/9”, “1/16” and “No polygon” by selecting from the [Reduction Rate] pull-down menu.

•If you want to generate points to fill in holes caused by missing data, set the [File Holes] set- ting to “On”.

•The [Remove] pull-down menu lets you select which points to remove from the imported data.

You can set this to any of the following: “None”, “Boundary(B.)”, “5deg. & B.”, “10deg. & B.”, “15deg. & B.”, or “20deg. & B.”

•If you want to filter the imported data, select the appropriate parameter from the [Filter] pull-down menu.

•If you want to save the raw scan data (.cdm) when importing, check the [Save CDM] checkbox.

92