Build – Rotate – Elements

nRotating the Element(s) by Entering a Value Directly

To rotate the element(s) by specifying the rotating angle, follow the procedure given below.

Note

If Build – Rotate – Elements mode was activated using the shortcut key, the element(s) cannot be moved by this method.

Operating Procedure The following steps must be carried out in Build – Rotate – Elements mode.

1 Click the right mouse button.

The [Build-Rotate-Elements] dialog box will appear.

2 Select X, Y or Z to be used as the pivot, and enter the desired rotating angle.

3 Click the [Apply] button.

The selected element(s) will rotate by the specified angle.

4 Click the [OK] button.

The [Build-Move-Points] dialog box will close, movement of the point(s) will be confirmed, and the Build-Move-Pointsmode will be canceled.

Chapter 2

Build

Menu

•If you change the angle and click the [Apply] button, the element(s) will rotate again according to the new angle. The new angle will not be added to the previous angle. It is an absolute angle from the original position.

•Clicking the [Cancel] button will cancel all the operations that have been performed since the dialog box was opened.

9i

910

900

700

300

199