File – Import – Digitizer – Step Scan (When VIVID 900/910 is Selected)

Chapter 2

File

Menu

9 Click the [OK] button.

The next specified angle will appear in [Current angle], and the object will be scanned for the next image.

•If a rotating stage has been selected by the Turn- table, the stage will turn to the next angle and then the object will be scanned.

Note

The rotating stage may rotate in the opposite direction during measurement depending on its type.

10 Repeat step 9 until shots from all the desired angles are captured.

When shots from all the desired angles are captured, the “Read the chart data ?” message dialog box will appear.

If calibration chart data already exists, click the [OK] button to import it. After the data has been imported, proceed to step 13.

If you click the [Cancel] button, the CScan the chart? The turntable will be move.” message dialog box will appear. If you click [OK]

910button the stage will move to the angle that

900allows measurement of the calibration, and the “Scanning the Calibration Chart.” message dialog box will appear.

•If the color and range images are not scanned at the same time, clicking the [Color Read] button or double-clicking on the image will capture a color image in the [General] tab in the [File-Import- Digitizer-Step Scan] dialog box and display it.

•Dragging the mouse on the color image will enlarge the image. If necessary, enable color cor- rection such as “Dark”, “Log” and “Smooth”, and load the color image again.

•If the type of rotating stage has not been desig- nated, turn the rotating stage manually to the next angle displayed in the “Next angle: ∗∗degree” message dialog box.

Memo

Step 8 and subsequent steps can be processed automati- cally. (For details, refer to page 90.)

•To cancel scan, click the [Cancel] button instead of the [OK] button, and repeat steps 6 to 8.

Note

If no chart data exists or the existing chart data does not match the measurement conditions, the following error messages will appear.

86