Chapter 2
File
Menu
File – Import – Digitizer – One Scan (When VIVID 900/910 is Selected)
Performing One Scan with the VIVID 910 or VIVID 900
This command is used to cause the VIVID 910
Warning
Never stare into the laser emitting window.
Do not place a lens, mirror or optical element in the passage of the laser beam. Doing so may converge the laser beam, resulting in damage to your eyes, burns or fire. To prevent the above accidents, make sure that a wall or similar which can block the laser beam is located behind the object.
Note |
|
|
|
| |
| Memo |
| |||
If the rotating stage does not operate correctly from the | • Before performing the procedure below, make sure that | ||||
dialog box, turn OFF the stage, turn it ON again, and |
| the digitizer you are going to use is selected by the File | |||
then try to operate it. |
| – Select Digitizer command. | |||
|
| • Note that although this version of the software supports | |||
|
|
| simultaneous use of two VIVID 910 or VIVID 900 | ||
|
|
| units, the software can only access the memory card | ||
|
|
| located in the unit with the higher SCSI ID. | ||
|
|
|
|
| For details of the File – Select Digitizer command, |
|
|
| Ref. |
| |
|
|
|
|
| refer to page 144. |
Operating Procedure |
|
|
|
| |
|
|
|
|
|
910
900
1 From the [File] menu, select [Import], [Digitizer] and then [One Scan].
The
2 Set an object in place.
If you are going to use the rotating stage, place the object on it.
3 To display the object in the middle of the image area, change the position of the object or move the instrument back and forth to change the view angle.
Memo
If necessary, replace the lens attached to the VIVID.
4 In the [Camera1] tab, select the desired scan mode (Fine or Fast).
•The monochrome monitor image currently captured by the VIVID 910 or VIVID 900 will appear in the image area of the dialog box.
74