13 Enter the desired element name, and set parameters.

Note

The element name must consist of up to 31 alphanumeric characters.

14 Click the [OK] button.

Each scanned image will be subjected to registration and displayed, and the “Proceed to registration?” message dialog box will appear. The element list will also show the element name specified at step 13 plus “rotation step”. The element name is highlighted, indicating that it is currently selected.

•The loaded data will be ready to be displayed in all windows. It will be displayed in the active window and the windows for which all the ele- ments are set to be displayed (i.e. the windows that are not set to “Selective”).

•When the data is loaded for the first time after the software is started, it will be fully framed in all the windows including those that are hidden automatically.

•If a rotating stage has been designated, the rotat- ing stage will rotate back to the original position before data reading starts.

15 Click the [OK] button.

Fine-registration of the element position will be performed and the data will be displayed again.

•If a rotating stage has been selected by the Turn- table, the stage will turn to the next angle and then the object will be scanned.

File – Import – Digitizer – Step Scan (When VIVID 900/910 is Selected)

•Select the desired rate from “1/1”, “1/4”, “1/9”, “1/16” and “No polygon” by selecting from the [Reduction Rate] pull-down menu.

•If you want to generate points to fill in holes caused by missing data, set the [File Holes] set- ting to “On”.

•The [Remove] pull-down menu lets you select which points to remove from the imported data.

You can set this to any of the following: “None”, “Boundary(B.)”, “5deg. & B.”, “10deg. & B.”,

“15deg. & B.”, or “20deg. & B.”

Chapter 2

• If you want to filter the imported data, select the

appropriate parameter from the [Filter] pull-down

File

Menu

menu.

 

•If you want to save the raw scan data (.cdm) when importing, check the [Save CDM] checkbox.

•If the [Save CDM] checkbox was checked at step 13, the [Remote-Save] dialog box will appear before the dialog box that asks whether you want to perform fine-registration.

q Enter the desired file name.

w Click the [Save] button.

Note

The file name must consist of alphanumeric characters only.

910

900

•If you are not going to perform fine-registration, click the [Cancel] button instead of the [OK] button.

Memo

Fine-registration can be cancelled even if it has started, by clicking the [Cancel] button in the dialog box that appears

during fine-registration.

83