Konica Minolta Build – Registration – Fine – Points

Build – Registration – Fine – Points

Performing Fine Registration of Selected Points

This command is used to perform fine registration of the points present in the selected elements.

Operating Procedure

1	From the element list, select the desired
	elements.		Memo
		• It is possible to select two or more elements by clicking
			them while holding down the [Shift] or [Ctrl] key.
		• Among the selected elements, the element located first
			in the element list will be used as the basis element for
Chapter 2			registration.

	2	From each selected element, select the
		points to be subjected to fine registra-
		tion.
	3	From the [Build] menu, select [Registra-
Build
Menu		tion], [Fine] and then click [Points].

The [Build-Registration-Fine-Points] dialog box will appear.

• The selected element will be ready to be displayed in all windows. It will be displayed if it is not displayed in the active window or the windows for which all the elements are set to be displayed.

4 Set the base element, and then click the [OK] button.

The program executes fine registration for the selected points in the selected elements. It then displays a dialog asking whether results are satisfactory.

5 Click the [OK] button. The menu will be exited.

9i

910

900

700

300

•To continue fine registration processing, click the [Repeat] button.

Memo

The [Error Average] and [Sigma] values are indicators of the correctness of the registration (the alignment).

In general, the closer to zero they are, the more accurate alignment is.

186