Window – Property
Displaying Window Properties
This command is used to display and set various types of information related to all the currently displayed windows.
Operating Procedure
Chapter 2
Window Menu
1 Click [Property] on the [Window] menu. The [Window – Property] dialog box will ap- pear.
2 Set the parameters.
Clicking the [View reset] button will change the Camera Settings as follows:
•Interest: 0.000, 0.000,
•Near plane: 500.000
•Far plane: 5000.000
•View angle: 45.0
To change the element for only the windows for which parameters have been set, check the [Select] checkbox and place a check mark for those elements.
“Selective” will appear in the window’s title bar.
•For those elements set in the element list to be hidden, it is not possible to set them to be shown by checking the [Select] checkbox.
•The [Flat] and [Smooth] radio buttons cannot be selected if Wireframe is selected as Rendering mode.
Note
For window views other than “Isometric” or “Perspec- tive” view, it is not possible to set [View angle] and certain “View point” and Interest” parameters.
•For “Front” and “Back” views, only [Z] parameter can be set.
•For “Top” and “Bottom” views, only [Y] parameter can be set.
•For “Right” and “Left” views, only [X] parameter can be set.
•For “Isometric” view, all parameters other than [View angle] can be set.
•For “Perspective” view, all the parameters can be set.
9i
910
900
700
300
3 Click the [Apply] button.
The windows will be updated according to the parameter settings
•If you change the parameter settings and click the [Apply] button again, the windows will be up- dated according to the new parameter settings.
4 Click the [OK] button.
This will confirm execution of window property change and close the dialog box.
230