Konica Minolta File – Import – Digitizer – One Scan (When VIVID 910 is Selected)

Chapter 2

File

Menu

File – Import – Digitizer – One Scan (When VIVID 910 is Selected)

Performing One Scan with the VIVID 910

This command is used to cause the VIVID 910 (VI-910) to scan the object one scan at a time using the remote control function of this software. Registration of multiple scan data can be performed by manually designating their corresponding points.

Warning

Never stare into the laser emitting window.

Do not place a lens, mirror or optical element in the passage of the laser beam. Doing so may converge the laser beam, resulting in damage to your eyes, burns or fire. To prevent the above accidents, make sure that a wall or similar which can block the laser beam is located behind the object.

Memo

Before performing the procedure below, make sure that the digitizer you are going to use is selected by the File

– Select Digitizer command.

Ref. For details of the File – Select Digitizer command, refer to page 144.

Operating Procedure

1 From the [File] menu, select [Import], [Digitizer] and then [One Scan].

The [File-Import-Digitizer-One Scan] dialog box will appear.

	2	Set an object in place.
910
		If you are going to use the rotating stage,
		place the object on it.
	3	To display the object in the middle of the
		Work window area , change the posi-

tion of the object or move the instrument back and forth to change the view angle.

•The monochrome monitor image captured by the VIVID 910 will appear in the Work window area of the dialog box.

Memo

If necessary, replace the lens attached to the VIVID.

50