Konica Minolta File – Import – Digitizer – Step Scan (When VIVID 900/910 is Selected)

File – Import – Digitizer – Step Scan (When VIVID 900/910 is Selected)

Performing Step Scan with the VIVID 910 or VIVID 900

This command is used to take two or more shots using the rotating stage via the remote control function of this software. If a rotating stage has been selected by the Turntable, rotation of the stage can also be controlled. After the necessary shots are taken, scan the calibration chart required for calibration of rotation. Data acquired from different angles will be subjected to registration, and the resulting data will appear.

Warning

Never stare into the laser emitting window.

Do not place a lens, mirror or optical element in the passage of the laser beam. Doing so may converge the laser beam, resulting in damage to your eyes, burns or fire. To prevent the above accidents, make sure that a wall or similar which can block the laser beam is located behind the object.

Note

If the rotating stage does not operate correctly from the dialog box, turn OFF the stage, turn it ON again, and then try to operate it.

Memo

•The calibration chart is an accessory of the rotating stage set.

•Before performing the procedure below, make sure that the digitizer you are going to use is selected by the File

– Select Digitizer command.

•If you have connected multiple VIVID 910 or VIVID 900 units, you can select the unit to be used by changing the SCSI ID. Note that the software can only load memory- card data from the VIVID unit with the highest SCSI ID.

Ref. For details of the File – Select Digitizer command, refer to page 144.

Chapter 2

File

Menu

nWhen Using Only the Rotating Stage

Operating Procedure

1	From the [File] menu, select [Import],	• The monochrome monitor image currently cap-
		tured by the VIVID 910 or VIVID 900 will appear
	[Digitizer] and then [Step Scan].

The [File-Import-Digitizer-Step Scan] dialog	in the image area of the dialog box.
box will appear.

2 Place the object on the rotating stage.

3	To display the object in the middle of the
	image area, change the position of the
	object or move the VIVID digitizer back	Memo
		If necessary, replace the lens attached to the VIVID .
	and forth to change the view angle.

910

900

79