Figure 4-1. Removing the Left-Hand Side Access Panel
To install the left side access panel (see Figure
1.Check to make sure that no tools or loose parts have been left inside the system chassis.
2.Make sure all option boards are firmly seated in their respective slots and that all interior cables are properly connected.
3.Insert the locking fingers on the top and bottom of the side access panel into their slots on the chassis. Then slide the side access panel forward as far as it will go.
Note: Ensure that the side access panel is installed properly and securely fastened. A cover sensor (intrusion switch) monitors the
4.Tighten the side access panel thumbscrews.
Note: If your system is already set up, plug the system back in, reconnect the peripherals, and power on the peripherals and system.
