SCSISelect Utility
The SCSISelect Utility detects and configures the SCSI controller located on the system board or an optional SCSI controller board installed in your system. This utility may be started with a simple key operation while POST is in progress and requires no specific
The SCSISelect Utility is used mainly to set the transfer rate of connected SCSI device. Use the SCSISelect Utility to:
!Change default values
!Check and/or change SCSI device settings that may conflict with those of other devices in the server.
Running the SCSISelect Utility
You access the SCSISelect Utility when you turn on or reboot your system. To run the utility, perform the following procedure:
1.
2.When this message appears on the video monitor: Press
3.Press Ctrl+A to run this utility. The SCSI utility starts. When the Adaptec SCSI Utility detects more than one
Bus : Device : Channel | Selected SCSI Adapter |
04 : 07 : A*AIC-7901
*Internal SCSI connector.
4.Once you select the adapter, the following screen is displayed:
Menu | Description |
Configure/View Host | Configure host adapter and device settings. |
Adapter Settings |
|
SCSI Disk Utilities | The utility scans the SCSI bus for SCSI devices, reports a |
| description of each device. Run these utilities before |
| configuring SCSI devices. |
5.If you wish to format a disk, verify disk media, or display a list of devices and their SCSI IDs, select “SCSI Disk Utilities”. If you wish to configure the adapter or a device, select “Configure/View Host Adapter Settings”.
