NEC 120Lg manual Removing the Tower Feet Disassembly and Reassembly

Tower Feet

Your tower system has four stabilizer feet located on the bottom of the chassis. To remove the stabilizer feet you must have the chassis positioned on its side with its stabilizer feet overhanging the edge of a table or workbench.

To remove the tower feet (see Figure 4-57), perform the following procedures:

1.Prepare your system for disassembly. See Preparing Your System for Disassembly and Reassembly earlier in this chapter.

2.Position the chassis on it side and move it to the edge of a table or workbench so that its stabilizer feet overhang the surface rim.

3.Remove and save the two screws attaching a foot to the bottom of the chassis.

4.Slide the foot towards the rear of the chassis and remove the foot from the chassis.

5.Repeat steps 3 and 4 to remove the other feet from the chassis.

A

B

C

AChassis foot

BScrews (2 per foot)

CWork surface

Figure 4-57. Removing the Tower Feet

4-62 Disassembly and Reassembly