9.1.12 Intercept Routing—No Destination

PC Programming Manual References

4.4 [2-3] Timers & Counters

→Dial / IRNA / Recall / Tone— Intercept Routing No Answer (IRNA)—Day, Lunch, Break, Night →DISA / Door / Reminder / U. Conf— DISA—InterceptTimer—Day, Lunch, Break, Night

5.12 [3-5-1] Incoming Call Distribution Group—Group Settings

→Overflow No Answer— Time out & Manual Queue Redirection—Destination-Day, Lunch, Break, Night

6.1[4-1-1] Wired Extension—Extension Settings →Intercept Destination

→Intercept No Answer Time

6.10[4-2-1] Portable Station—Extension Settings →Intercept Destination

→Intercept No Answer Time

7.3[5-3-1] Voice Message—DISASystem—Option 1— DISA Intercept—Intercept when all DISA ports are busy

12.6[10-4] Miscellaneous

Intercept—Intercept Routing - DND (Destination sets DND.)

Intercept—Routing to Operator - No Destination (Destination is not programmed.)

Intercept—Intercept Routing for Extension Call

PT Programming Manual References

[203] Intercept Time

[604] Extension Intercept Destination

[625] Destination for Overflow Time Expiration

Feature Manual References

4.1.7DISA (Direct Inward System Access)

4.1.9DND (Do Not Disturb)

9.1.12 Intercept Routing—No Destination

Description

Directs a CO line call to an operator when the call has no assigned destination.

Conditions

Intercept Routing—No Destination on/off

Intercept Routing—No Destination can be enabled or disabled for the entire system, through system programming. If disabled, the caller will hear a reorder tone.

Note that calls received through an ELCOT/LCOT or T1 (LCOT/GCOT) card will always be directed to an operator, even when this feature is disabled.

If an operator is not assigned:

The default intercept destination will be the extension connected to the lowest numbered port, on the card installed in the lowest numbered slot.

Intercept Routing—No Destination also applies to calls from doorphones.

Document Version 2008-11

Feature Manual

167

Page 167
Image 167
Panasonic KX-TDA50 manual Intercept Routing-No Destination on/off, If an operator is not assigned