Panasonic KX-TDA50 manual Disa Intercept Routing-DND, Disa Intercept Routing-No Answer

4.1.7 DISA (Direct Inward System Access)

DISA Intercept Routing—DND

If the destination called by the outside party is in DND mode and Idle Extension Hunting is not available, one of the following can be selected through system programming:

a.Busy Tone: The caller will hear a busy tone.

b.Enable: DND will redirect the call to the preprogrammed destination on an extension basis.

c.OGM: An outgoing message (OGM) will be sent to the caller. The message for DND mode can be assigned for each outgoing message (OGM) which has a DISA floating extension number.

→7.3 [5-3-1] Voice Message—DISA System— DISA Intercept—Intercept when destination through DISA sets DND

DISA Intercept Routing—No Answer

If a destination is not available to answer a DISA call within a preprogrammed time period (DISA Intercept time) after the call is reached, the call will be redirected to the programmed destination by the Intercept feature.

If the intercept destination is not available to answer the call within a preprogrammed time period (DISA Disconnect Time after Intercept) after the DISA Intercept time expires, the call will be disconnected.

4.4[2-3] Timers & Counters—DISA / Door / Reminder / U. Conf

→ DISA—InterceptTimer—Day, Lunch, Break, Night

→ DISA—Disconnect Timer after Intercept

6.1[4-1-1] Wired Extension—ExtensionSettings—Intercept Destination— Intercept Destination—When called party does not answer—Day, Lunch, Break, Night

6.10[4-2-1] Portable Station—ExtensionSettings—Intercept Destination— Intercept Destination—When called party does not answer—Day, Lunch, Break, Night

[604] Extension Intercept Destination

Walking COS Through DISA

If the caller performs Walking COS (extension number and PIN entry) while hearing a DISA message, the security mode can be temporarily changed to No Security mode (→ 20.1.1 Walking COS). After performing Walking COS, the following features are available, using the settings of the specified extension:

•Intercom call

•TIE line call

•CO line call

•Call Forwarding (FWD)/Do Not Disturb (DND) setting (→ 4.1.9 DND (Do Not Disturb), → 6.1.6 FWD (Call Forwarding))

•Incoming Call Distribution Group Log-in/Log-out (→ 9.1.3 ICD Group Features—Log-in/Log-out)

•Absent Message setting (→ 1.1.1 Absent Message)

•Extension Dial Lock (→ 5.1.4 Extension Dial Lock)

•Time Service Switching Mode (→ 17.1.5 Time Service)

DISA Automatic Walking COS

Registered outside destinations such as cellular phones can be automatically recognized as PBX extensions when calling through DISA. When the Caller ID of a received CO line call matches an entry in the System Speed Dialing Table, the calling telephone is given Walking COS authorization as assigned to the corresponding CLI destination extension. Therefore, the "CLI destination" setting in the System Speed Dialing Table is used here to specify the target extension that the calling telephone will be recognized as for Walking COS.

[Programming Example of DIL Table]

CO Line		CLI			DIL Destination
No.	Day	Lunch	...	Day		Lunch	...
01	Disable	Disable	...	501		501	...
				(DISA)		(DISA)

80

Feature Manual Document Version 2008-11