Panasonic KX-TDA50 manual Automatic Time Adjustment, Daylight Saving Time Setting

1.1.7 Automatic Time Adjustment

Destination

DISA

Analog/ISDN Remote Maintenance

Idle Line Access no. + Phone no.

Trunk Group Access no. + Trunk Group no. + Phone no.

Extension of Another PBX (via TIE Line, Access with PBX Code)

Extension of Another PBX (via TIE Line, Access without PBX Code)

Availability

*1 A PS destination can be used to forward fax calls to a fax machine at another PBX connected by TIE line. A virtual PS can be specified as the destination of fax calls. Then, the extension number of the fax machine at the other PBX can be specified as the FWD—ALL Calls destination for calls to that virtual PS. (→ 19.1.2 Virtual PS)

Conditions

•Hardware Requirement: An MSG2 card or ESVM2 card

•This feature is only effective for calls arriving on DISA lines.

•If a fax signal is not detected before the DISA Intercept Routing—No Dial timer expires, the call is redirected to the operator extension, and fax detection ends.

Installation Manual References

2.5.3MSG2 Card (KX-TDA5191)

2.5.5ESVM2 Card (KX-TDA5194)

PC Programming Manual References

7.4 [5-3-2] Voice Message—DISA Message— Fax Extension (KX-TDA50 only)

Feature Manual References

4.1.7DISA (Direct Inward System Access) 21.2 Exclusive Features Table

1.1.7Automatic Time Adjustment

Description

The PBX clock can be adjusted automatically in the following two ways:

1.Daylight Saving Time Setting

The start and end dates of Daylight Saving Time can be programmed. The PBX clock will automatically adjust itself one hour forward or backward at 2:00 A.M. on the programmed date, if enabled through system programming. At 2:00 A.M. on the start date, the clock will change to 3:00 A.M., and at 2:00 A.M. on the end date, the clock will change to 1:00 A.M.

Note

If a Timed Reminder (Remote Wake-up call) is set:

–On the Daylight Saving Time start date, a reminder set for between 2:00 A.M. and 3:00 A.M. will not ring.

24

Feature Manual Document Version 2008-11