Peerless Industries KX-TDA100, KX-TDA15 manual Number Description Pattern Date, Time, Ext, CO Trunk

1.25 Administrative Information Output Features

[Explanation]

The following table explains the SMDR contents which are based on the numbers in the previous pattern examples. For the programmable items, refer to the following [Programmable Items].

Number in
the	Item	Description
Pattern
(1)	Date	Shows the date of the call.
(2)	Time	Shows the end time of a call as Hour/Minute/AM or PM.
(3)	Ext	Shows the extension number, floating extension number,
	(Extension)	etc., which was engaged in the call.
		Also shows the following codes:
		Dxxx: Outgoing trunk call from a doorphone
		(xxx=doorphone number) (	1.16.1 Doorphone Call)
		Txxx: Outgoing trunk call by TIE line service (xxx=trunk
		group number)
		*xxx: Verified call (xxx=verified code) ( 1.8.6 Verified
		Code Entry)
(4)	CO (Trunk)	Shows the trunk number used for the call.
		For patterns A and B, "00" will be shown for trunk
		numbers over hundred.
(5)	Dial Number	[Trunk Call]
		Outgoing Trunk Call
		Shows the dialled telephone number.
		Valid digits are as follows:
		0 through 9, , #
		P: Pause
		F: EFA signal
		=: A Host PBX Access code (	1.5.4.7 Host PBX Access
		Code (Access Code to the Telephone Company from a
		Host PBX))
		. (dot): Secret dialling
		X: Privacy dial
		–:Transferred call
		If the transfer destination extension enters some digits,
		the entered digits will be added after "–".
		Incoming Trunk Call
		Shows <I> + the caller’s identification name/number.
		It is also possible to show the DDI/DID/MSN call
		information. In this case, <D> + DDI/DID/MSN
		name/number is added before <I> .
		[Outgoing Intercom Call]
		Shows the dialled extension number followed by "EXT".
		[Log-in/Log-out]
		Shows the log-in or log-out status.
(6)	Ring	Shows the ring duration before answering a call in
		Minutes/Seconds.

232 Feature Guide