1.25 Administrative Information Output Features
•The PBX waits for a preprogrammed time period ( 
Call Duration Count Starting Time for LCOT [208]) between the end of dialling and start of the SMDR timer for outgoing trunk calls. When the PBX has sent out all dialled digits to the telephone company and this timer expires, the PBX starts counting the call. A display PT shows the elapsed time of the call. The starting time and the total duration of the call are recorded on SMDR.
If the reverse signal detection has been set ( 
1.5.4.5 Reverse Circuit), the PBX will start counting the call after detecting the reverse signal from the telephone company regardless of the above timer.
•Serial Interface (RS-232C) Parameters
The following communication parameters can be assigned for the Serial Interface (RS- 232C) port ( 
a)New Line Code: Select the code for the PC or printer. If the PC or printer automatically feeds lines with carriage return, select "CR." If not, select "CR+LF."
b)Baud Rate: A baud rate code indicates the data transmission speed from the PBX to the PC or printer.
c)Word Length: A word length code indicates how many bits compose a character.
d)Parity Bit: A parity code indicates what type of parity is used to detect an error in the string of bits composing a character. Make an appropriate selection depending on the requirements of the PC or printer.
e)Stop Bit Length: A stop bit code indicates the end of a bit string which composes a character. Select an appropriate value depending on the requirements of the PC or printer.
Installation Manual References
Installation Manual
2.11.1Connection of Peripherals
6.10.1Connection of Peripherals
Feature Guide References
1.1.1.3Direct Inward Dialling (DID)/Direct Dialling In (DDI)
1.1.1.4Multiple Subscriber Number (MSN) Ringing Service
1.2.2.6
1.11.1 Call Transfer
1.16.6 Direct Inward System Access (DISA) 1.28.1 TIE Line Service
