Peerless Industries KX-TDA30 Flash/Recall/Terminate, Explanation of Each Mode, Terminate Button

1.10 Conversation Features

1.10.6 Flash/Recall/Terminate

Description

The FLASH/RECALL button (Flash/Recall mode or Terminate mode) or Terminate button (Terminate mode) is used when a PT user disconnects the current call and originates another call without hanging up first. It performs as going on-hook and then going off-hook.

[Explanation of Each Mode]

Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the line used last. For example, if a trunk call is disconnected, the extension user will hear a new dial tone from the telephone company.

Terminate Mode: Disconnects the line and the extension user hears the dial tone determined by the Line Preference—Outgoing setting. ( 1.5.5.2 Line Preference—Outgoing)

Conditions

•FLASH/RECALL Button Mode

One of the following modes can be selected for each extension through system programming:

–Flash/Recall mode

–Terminate mode

–External Feature Access (EFA) mode. ( 1.10.7 External Feature Access (EFA))

•Terminate Button

A flexible button can be customised as the Terminate button.

•Disconnect Time (Only for Flash/Recall Mode)

The amount of time between successive accesses to the same trunk is programmable for each trunk port ( LCOT Disconnect Time [418]).

•This feature outputs an SMDR call record ( 1.25.1 Station Message Detail Recording (SMDR)), restarts the call timer, inserts the automatic pause, and checks the TRS/Barring level ( 1.8.1 Toll Restriction (TRS)/Call Barring (Barring)) again.

•If the ARS mode is on ( 1.9.1 Automatic Route Selection (ARS)) or if a trunk call is established through the INTERCOM button or ICD Group button, the Terminate mode will be always effective even though the Flash/Recall mode has been set.

Feature Guide References

1.19.2 Flexible Buttons

Feature Guide 123