RGB Spectrum DGy 201x manual Eraseremovabledisk, Mount

C O M M A N D L I N E I N T E R F A C

.E

		.
		Commands
		. . .
Table 6-8Clip and Disk Commands (Continued)
Command	Argument	Description
ERASEREMOVABLEDISK	(none)	This command erases the entire contents of
		the removable disk drive.
		This is an interactive command that will prompt
		for confirmation that you wish to proceed. The
		process may take several minutes, and the
		DGy will automatically reboot as soon as the
		procedure is complete. Only recorded data is
		stored on the disk. The DGy application
		software is not stored on disk.
		WARNING: This command does not have an
		undo feature.
MOUNT	<ipaddress:sharename>	This DGy 201x optional feature supports the
		ability to mount an external network mapped
		disk drive for recording and replaying clips.
		Note that this capability requires the use of
		Linux or an Allegro network file server software
		for the Windows OS.
		The MOUNT command provides the ability to
		set up a network mapped NFS remote disk
		drive that the DGy can use to store and recall
		recordings. The location of the remote drive is
		identified by the network address (ipaddress)
		and sharename is the name of the shared
		drive as configured in the NFS server on the
		remote host; the syntax of this name may vary
		with different NFS servers.
		It is recommended that the IT manager
		consulted before executing the mounting
		procedure.
		Example: To mount the /usr/dgy NFS share on
		a Linux host at IP node 192.168.1.123, issue
		the following:
		mount 192.168.1.123:/usr/dgy
		Once the disk is mounted the drive will be
		identified in the Clip Browser as \remot.
		To record, play or list clips on the remote drive
		execute the command CD/rgb/mp1 followed by
		the desired clip command (PLAY, RECORD
		...).
		The settings associated with the remote drive
		are saved in non-volatile memory, and the DGy
		will automatically attempt to reconnect after a
		reboot. To select a new remote drive you must
		first unmount the current drive (see the
		UMOUNT command for details).
		Note: After mounting a drive verify that the
		drive is mounted can be accomplished using
		the VOLINFO command (see VOLumeINFO
		for details).

350-9047 v3.0.1 DGy Model 201x User’s Guide 111