RGB Spectrum DGy 201x manual At the prompt, begin a new Telnet session

F I R M W A R E U P G R A D

.E

. Manual Update Procedure ..

.

7.Type the command bin and press ENTER.

Caution

Failure to enter the bin command will cause the files to be corrupted on transfer.

8.Upload the firmware to the DGy 201x by issuing the put command followed by the firmware file name. The file name is case sensitive and must be entered exactly. In the example shown in Figure C-8 the entry is:

put FWDGY.3.08.tgz press ENTER.

9.Type ls and press ENTER to verify that the file was uploaded.

10.Type bye and press ENTER to exit ftp.

. . . . . . . . .	11. At the prompt, begin a new Telnet session.
UPDATE FIRMWARE

Figure C-9Update Firmware Command

12.Type the ufw command and press ENTER.

13.Type y to proceed or n to terminate the process.

After about 30 seconds, the connection to the host will be lost.

Important

Communications with the DGy 201x will be lost during the installation process. This is normal and does not indicate that there is a problem with the installation process. This process approximately two minutes.

DO NOT turn the power off during this time.

. . . . . . . . .	14)	Re-establish the FTP connection as described in Step 4. above.
FTP FPGA FILE
	15.	Enter the user name rgb.
	16.	Enter the password spectrum (case sensitive).

350-9047 v3.0.1 DGy Model 201x User’s Guide 146