RGB Spectrum DGy 201x Graphics Loop, Graphics Output, Audio Inputs, Audio Outputs, Ethernet Port

I N S TA L L A T I O N A N D S E T U

.P

. Rear Panel ..

.

3)Graphics Loop

Use the Graphics Loop connector to pass the unprocessed input signal to an external device such as a monitor. This connector provides looping for both the digital (DVI) and analog RGB signals. This is an active loop, so there will be no output when the DGy 201x has no power applied.

4)Graphics Output

This Graphics Output connector provides both analog RGB and digital DVI output signals on a DVI-I connector. When the DGy 201x is in Play mode, the output signal plays back from recorded material on a disk. When DGy 201x is in Record mode, the output signal displays the signal present at the Graphics Input connector.

A DGy equipped with the simultaneous record/play option will display the playback on the Graphics Output connector whenever the DGy is in Play mode even when the unit is recording.

5)Audio Inputs

The DGy 201x provides stereo recording capability. A pair of RCA phono Audio Input connectors accept analog audio signals for left and right channels. The Audio Input will accept either line or microphone level inputs. A choice of sample rates is provided.

6)Audio Outputs

A pair of RCA phono Audio Output connectors supply the line level left and right analog audio output signals.

7)Ethernet Port

A standard RJ-45 connector is provided for the Ethernet 100/1000 Base-T control port. This port is used to control the DGy 201x with the RGB Spectrum graphical interface (Web Control Panel), Telnet command line interface, or for the transfer of recorded clips over a network (using FTP).

8)RS-232 Port

A standard 9-pin sub-miniature D connector provides serial connection to an external RS-232equipped control device. The serial port does not support a graphical user interface.

9)IRIG Ports (option)

The optional IRIG timecode input accepts IRIG-B timecode in either DCLS or 1kHz modulated formats (B123 format). The looping output can be used to provide a reference signal to other IRIG-B compatible devices.

Note

The GPIO connector is non-operational at this time.

350-9047 v3.0.1 DGy Model 201x User’s Guide 16