COMMUNICATIONS SETUP | B |
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
|
LAUNCHING A
HYPERTERMINAL
. . . . . WINDOW. . . .
IN. . THIS. . . .APPENDIX. . . . . . . . . . . . . . . . . . . . . . .
This appendix provides specific communications setup procedures that are referenced in Chapter 2, Installation and Set Up. The following topics are discussed:
•Serial Communications
•Ethernet Control
SERIAL. . . . . .COMMUNICATIONS. . . . . . . . . . . . . . . . . . . . . . .
A command line interface is provided for DGy 201x using the serial port. A full description of available commands is provided in Command Line Interface on page 85.
PCs running the Windows Operating system are provided with serial emulation software known as Hyperterminal. This provides a convenient method to communicate with the DGy 201x.
Use the following steps to launch a Hyperterminal window on a PC:
1.On the PC, click Start > Programs > Accessories > Communica- tions > Hyperterminal.
Figure B-1 Hyperterminal Path
DGy Model 201x User’s Guide | 131 |
