RGB Spectrum DGy 201x Command Arguments Description TiMingLIST, TiMingLISTCLEAR, TiMingLISTLOAD

C O M M A N D L I N E I N T E R F A C

.E

		.
		Commands
		. . .
Table 6-2Input Commands (Continued)
Command	Arguments	Description
TiMingLIST	[<1..160> [<1..160>]]	Displays the list of saved input and output timings.
	[ACTIVE]	If two numeric arguments are supplied, displays all
		entries in the range. ACTIVE, displays only the
		active timings.
TiMingLISTCLEAR	(none)	Deletes all user entries from the Timing List.
TiMingLISTLOAD	<100 ...160> <name>	This command is used to create and save a user
	<hfp> <hs> <hbp>	timing set to the Timing List.
	<hact> <vfp> <vs>	User defined entries may be saved to the list using
	<vbp> <vact> <hfreq>
		slots 100 - 160. Timing slots 1 - 99 are reserved for
	<sync> <hpol> <vpol>
		factory defined timing settings.
	<il>
		The name parameter is a name that is used to
		identify the timing set (for example mytiming3).
		hfp - width of the horizontal front porch (pixels)
		hs - width of the horizontal sync pulse (pixels)
		hbp - width of horizontal back porch (pixels)
		hact - width of the active picture area (pixels)
		vfp - width of the vertical front porch (pixels)
		vs - width of the vertical sync pulse (pixels)
		vbp - width of vertical back porch (pixels)
		vact - height of the active picture area (pixels)
		hfreq - horizontal frequency (Hz)
		sync - type of sync signal (analog 3, 4 or 5 wire)
		hpol - polarity of horizontal sync pulse (0=negative,
		1=positive)
		vpol - polarity of vertical sync pulse (0= negative,
		1=positive)
		il - interlace (0 = non interlace, 1 = interlace)

350-9047 v3.0.1 DGy Model 201x User’s Guide 95