Chapter 8 Device Manipulation

4If you want to import devices whose serial numbers are not entirely consecutive, enter a value in the Step field. For example, if you want to skip every second serial number, enter 2.

5Click Import.

6View the Device List panel to verify the device is registered to Vantage Access successfully.

8.1.5Verifying Device Import/Registration

When the file import is successful, you should see the new entry or entries in the Device List panel.

If you cannot see the new entry or entries, or the registered icon ( ) does not display, check the system logs and make sure the XML or CSV file format is correct.

Figure 41 Device Import > Verify in Device List

8.1.6 Device Setup for Registration

After you have uploaded the XML file for a device to the Vantage Access, you must then configure the device to allow remote management from the Vantage Access. This communication protocol is known as TR-069. Refer to the user’s guide that comes with your device for more information.

The following describes the steps to configure settings on a ZyXEL device. Steps may vary depending on your device. Refer to the documentation that comes with your device.

1To activate TR-069 on the ZyXEL device, access the CLI and enter the following commands.

wan tr load

Enable TR-069 configuration.

wan tr active 1

Activate TR-069 remote management.

wan tr acsUrl

Sets the IP address of the Vantage Access server. For example,

172.25.21.174/TR069

172.25.21.174.

wan tr periodicEnable 1

Enable periodic information update to the server.

wan tr informInterval 30

Set the information update time. For example, 30 seconds.

wan tr debug on

Enable TR-069 debug mode to view logs.

 

115

Vantage Access User’s Guide