Chapter 19 General Device Setup

Click Data Model > InternetGatewayDevice > Layer3Forwarding > Forwarding.

Figure 226 TR-098 Amendment 1: Layer3 Forwarding Table

19.9.2 Layer3 Forwarding Table Details

Use the detailed Forwarding screen to configure the layer 3 forwarding table on the device.

Select a registered device in the Device List window and click Provision > Data Model > InternetGatewayDevice > Layer3Forwarding > Forwarding. Then click on an index number.

Figure 227 TR-098 Amendment 1: Layer3 Forwarding Table: Details

The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for other field descriptions.

Table 124 TR-098 Amendment 1: Layer3 Forwarding: Forwarding

PARAMETER

VALUE

NAME

 

Enable

This field displays 1 to indicate that entry in the forwarding table is enabled.

 

A value of 0 means that the rule is disabled. This is the default setting for new

 

forwarding entries.

 

 

Status

This field displays the status of the forwarding entry.

 

 

Type

This field displays the route type.

 

Default sets the device to route packets with any destination.

 

Host sets the device to route packets to a specific destination IP address.

 

Network sets the device to route packets to an IP network.

 

 

DestIPAddress

This field displays the destination IP address in dotted decimal notation for the

 

route entry.

 

 

DestSubnetMask

This field displays the destination subnet mask in dotted decimal notation for

 

the route entry.

 

 

SourceIPAddress

This field displays the source IP address in dotted decimal notation for the route

 

entry.

 

 

 

287

Vantage Access User’s Guide