Chapter 21 WAN Device

21.3 WAN DSL Interface Configuration

Use the WANDSLInterfaceConfig to configure the DSL connection for Internet access. DSL connection setup is independent of other WAN interface parameter settings.

Select a registered device in the Device List window and click Data Model > InternetGatewayDevice > WANDevice. Click a number and WANDSLInterfaceConfig to display the screen.

Figure 277 TR-098 Amendment 1: WAN Device: WANDSLInterfaceConfig

The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for other field descriptions.

Table 150 TR-098 Amendment 1: WAN Device: WANDSLInterfaceConfig

PARAMETER NAME

VALUE

Enable

This field displays 1 to indicate that the link is active; otherwise, it displays

 

0.

Status

This field displays the link status.

 

 

ModulationType

This field displays the modulation method used on the link.

 

 

LineEncoding

This field displays the line encoding method used to establish a connection

 

to the ISP.

 

 

DataPath

This field displays whether the link uses fast (lower latency) or interleave

 

(lower error rate) data path.

 

 

330

 

Vantage Access User’s Guide