|
| Chapter 21 WAN Device |
| Table 160 | |
| PARAMETER NAME | VALUE |
| RSIPAvailable | This field displays whether the |
|
| supported on the device. |
|
|
|
| NATEnabled | This field displays 1 to indicate that the NAT (Network Address Translation) |
|
| feature is enabled for this link; otherwise the field displays 0. |
| AddressingType | This field displays DHCP to set the device to obtain a dynamic IP address |
|
| from the ISP for this link on the WAN. |
|
| This field displays Static to set the link to use a fixed WAN IP address. |
|
| Then configure the fields below. |
|
|
|
| ExternalIPAddress | This field is applicable when you select Static in the AddressingType field. |
|
|
|
| SubnetMask | This field is applicable when you select Static in the AddressingType field. |
|
|
|
| DefaultGateway | This field is applicable when you select Static in the AddressingType field. |
|
|
|
| DNSEnabled | This field displays whether is the device to resolve domain names through |
|
| this link. |
|
|
|
| DNSOverrideAllowed | This field displays 1 when a |
|
| DNS entry received on the WAN; otherwise, this field is 0. |
|
|
|
| DNSServers | This field displays the IP address(es) of the DNS server(s). Multiple IP |
|
| addresses are separated by a comma. |
|
|
|
| MaxMTUSize | This field displays the maximum size (between 1 and 1540) for the Ethernet |
|
| frames allowed on this link. |
|
|
|
| MACAddress | This field is applicable when you select Enable in the |
|
| MACAddressOverride field. |
|
| This field displays the MAC address on this link. |
|
|
|
| MACAddressOverride | This field displays 1 to change the MAC address of this interface in the |
|
| MACAddress field. |
|
| This field is 0 if you do not allow MAC address modification. |
|
|
|
| ConnectionTrigger | This field displays how the device will establish a connection for Internet |
|
| access. Choices are AlwaysOn, OnDemand and Manual. |
|
|
|
| RouteProtocolRx | This field displays the routing protocol (RIP1, RIP2 or OSPF) the link is to |
|
| use. Off means the routing feature is disabled. |
|
|
|
| ShapingRate | This field displays the rate (in bits per second) the device shapes the |
|
| outgoing traffic to. |
|
|
|
| ShapingBurstSize | This field displays the burst size (in bytes) for traffic shaping. |
|
|
|
| PortMappingNumberOfE | This field displays the number of port mappings on this link. |
| ntries |
|
|
|
|
Use the PortMapping screen to view the port mapping instance for the WAN IP connection. Refer to Section 11.2.4 on page 132 for other field descriptions.
1Select a registered device in the Device List window and click Data Model > InternetGatewayDevice > WANDevice.
2Click a number and WANConnectionDevice.
3Click a number and WANIPConnection.
4Click a number and PortMapping to display the screen as shown.
| 345 |
Vantage Access User’s Guide | |
|
|