Chapter 21 WAN Device

The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for other field descriptions.

Table 157 TR-098 Amendment 1: WAN Device: WANDSLLinkConfig

PARAMETER NAME

VALUE

Enable

This field displays 1 to indicate that the DSL link is active; otherwise, this

 

field displays 0.

LinkStatus

This field displays the link status (Up, Down, Initializing or Unavailable).

 

 

LinkType

This field displays the type for this DSL link.

 

EoA sets the device to use the bridged Ethernet over ATM (RFC2684) link

 

type.

 

IPoA sets the device to use the routed IP over ATM (RFC2684) link type.

 

PPPoA sets the device to use the PPP over ATM (RFC2364) link type.

 

PPPoE sets the device to use the PPP over Ethernet on bridged Ethernet

 

over ATM (RFC2516, RFC2684) link type.

 

CIP sets the device to use the Classical IP over ATM (RFC1577) link type.

 

Unconfigured means an unknown link type.

 

 

AutoConfig

This field displays whether the auto-configuration feature is enabled or

 

disabled for this DSL link.

 

 

ModulationType

This field displays the type of modulation used on the interface associated

 

to this DSL link.

 

 

DestinationAddress

This field displays the destination address for the DSL link. The type of

 

address you enter varies depending on the connection type.

 

This field displays the VCI/VPI for a PVC connection.

 

This field displays an ATM connection name or ATM address for an SVC

 

connection.

 

 

ATMEncapsulation

This field displays the encapsulation (LLC or VCMUX) to use for this DSL

 

link.

 

 

FCSPreserved

This field displays 1 to include a checksum in the ATM payload for error

 

correction.

 

0 means the checksum is not included in the ATM payload. No error

 

correction is available.

 

 

VCSearchList

This field displays the VCI/VPI number pairs (separated by a comma) the

 

link uses to establish a connection if the destination address specified

 

cannot be reached.

 

 

ATMAAL

This field displays the ATM Adaptation Layer (AAL) the link uses.

 

 

ATMTransmittedBlocks

This field displays the number of ATM blocks transmitted successfully.

 

 

ATMReceivedBlocks

This field displays the number of ATM blocks received successfully.

 

 

ATMQoS

Select the ATM Quality of Service (QoS) method to use on this link.

 

 

ATMPeakCellRate

This field displays the peak cell rate (between 0 and 4294967295) for the

 

upstream traffic in cells per second.

 

 

ATMMaximumBurstSize

This field displays the maximum burst rate (between 0 and 4294967295)

 

for the upstream traffic in cells.

 

 

ATMSustainableCellRate

This field displays the sustainable cell rate (between 0 and 4294967295) for

 

the upstream traffic in cells per second. This value is used for traffic

 

shaping.

 

 

AAL5CRCErrors

This field displays the number of AAL5 layer cyclic redundancy check

 

errors.

 

 

 

339

Vantage Access User’s Guide