Chapter 4 Initial Setup

3Click Import.

4When the file import is successful, you can Search for the new entry or entries. The new devices are not yet registered. To complete the device registration, see Section 4.2.4 on page 96.

If you cannot see the new entry or entries, check the system logs and make sure the XML or CSV file format is correct.

Figure 33 Check New Device

4.2.4 Device Setup for Registration

You must configure the managed device to allow remote management from Vantage Access. Refer to the user’s guide that comes with your compatible device for more information. The following shows how to enable TR-069 communication protocol between a ZyXEL compatible device and Vantage Access.

The following describes the steps to configure settings on a ZyXEL compatible device. Steps may vary depending on your device. Refer to the documentation that comes with your device.

1To activate TR-069 on the ZyXEL compatible device, access the CLI and enter the following commands.

wan tr load

Enables TR-069 configuration.

wan tr active 1

Activates TR-069 remote management.

wan tr acsUrl

Sets the IP address of the Vantage Access server. For example,

172.25.21.174/TR069

172.25.21.174.

wan tr periodicEnable 1

Enables periodic information update to the server.

wan tr informInterval 30

Sets the information update time. For example, 30 seconds.

wan tr debug on

Enables TR-069 debug mode to view logs.

wan tr save

Saves the settings.

wan tr reset

Sets the device to register to the Vantage Access server right away.

2Once connected to the network, the ZyXEL device automatically locates and registers to the Vantage Access server.

96

 

Vantage Access User’s Guide