ZyXEL Communications vantage access manual 150

Chapter 13 General Device Setup

Figure 76 TR-069: Layer3 Forwarding Table: Details

The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for other field descriptions.

Table 34 TR-069: Layer3 Forwarding: Forwarding

PARAMETER	VALUE
NAME
Enable	This field displays 1 to indicate that entry in the forwarding table is enabled.
	A value of 0 means that the rule is disabled. This is the default setting for new
	forwarding entries.
Status	This field displays the status of the forwarding entry.
Type	This field displays the route type.
	Default sets the device to route packets with any destination.
	Host sets the device to route packets to a specific destination IP address.
	Network sets the device to route packets to an IP network.
DestIPAddress	This field displays the destination IP address in dotted decimal notation for the
	route entry.
DestSubnetMask	This field displays the destination subnet mask in dotted decimal notation for
	the route entry.
SourceIPAddress	This field displays the source IP address in dotted decimal notation for the route
	entry.
SourceSubnetMask	This field displays the source subnet mask in dotted decimal notation for the
	route entry.
GatewayIPAddress	This field displays the IP address of the gateway in dotted decimal notation for
	the route entry.
Interface	This field displays the hierarchical name of the WAN interface associated to this
	route entry. For example, “InternetGatewayDevice.WANDevice.1.-
	WANConnectionDevice.1.WANPPPConnection.1”
ForwardingMetric	This field displays the number of hops to the destination. This is associated to
	the cost of the route.
	-1means this route is not used to forward traffic.
MTU	This field displays the maximum Ethernet packet size allowed on this route.

150
	Vantage Access User’s Guide