Chapter 23 STB Service

The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for other field descriptions.

Table 233 TR-135: STBService: Components: IP

PARAMETER NAME

VALUE

InboundNumberOfEnt

This displays the number of inbound instances.

ries

 

 

 

OutboundNumberOfE

This displays the number of outbound instances.

ntries

 

 

 

ActiveInbounds

This displays the number of active inbound streams.

 

 

ActiveOutbounds

This displays the number of active outbound streams.

 

 

23.3.13 Front End RTCP Setup

You can view and configure front end RTCP (RTP Control Protocol) settings in the RTCP screen.

1Select a registered device in the Device List window and click Data Model > Device > Services > STBService.

2Click a number and Components.

3Click FrontEnd.

4Click IP > RTCP to display the screen.

Figure 402 TR-135: STBService: Components: IP: RTCP

The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for other field descriptions.

Table 234 TR-135: STBService: Components: IP: RTCP

PARAMETER NAME

VALUE

Enable

This displays whether RTCP receiver report generation is enabled.

 

 

Status

This displays the status of RTCP receiver report generation.

 

 

TxRepeatInterval

This displays the transmission repeat interval in milliseconds.

 

 

23.3.14 Front End RTP AVPF Setup

You can view and configure front end RTP AVPF settings in the RTPAVPF screen.

1Select a registered device in the Device List window and click Data Model > Device > Services > STBService.

2Click a number and Components.

3Click FrontEnd.

 

427

Vantage Access User’s Guide