Chapter 22 Voice Service
3Click a number to display the configuration screen.
Figure 311
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for other field descriptions.
Table 170
PARAMETER NAME | VALUE |
Enable | This field displays Enabled to indicate the profile is active. |
| This field displays Disabled to indicate the profile is not active. |
| This field displays Quiescent to prevent new session generation on the active |
| line(s). |
|
|
Reset | This field displays 1 to reset the line(s) on which the profile is applied. |
| This field displays 0 to disable line reset. |
|
|
NumberOfLines | This field displays the number of lines associated with the voice profile. |
|
|
Name | This field displays a descriptive name (up to 64 characters) to identify the |
| profile. |
|
|
SignalingProtocol | This field displays the signaling protocol the profile is to use. |
|
|
MaxSessions | This field displays the maximum number of simultaneous sessions allowed on |
| the line(s) on which the profile is applied. Enter a number between 1 and |
| 4294967295. |
|
|
DTMFMethod | This field displays the DTMF method the profile is to pass. |
|
|
DTMFMethodG711 | This field displays the DTMF method the profile is to pass if the current codec |
| is G.711. |
|
|
Region | This field displays the geographical area this profile is used. This may be used |
| by the device to customize localization settings. |
|
|
DigitMap | This field displays the requirements before the device sends out a request. |
|
|
DigitMapEnable | This field displays 1 to use a digitmap for voice transmission; otherwise, this |
| field is 0. |
|
|
STUNEnable | This field displays 1 to allow STUN to work in a NAT environment; otherwise, |
| this field displays 0. |
364 |
| |
Vantage Access User’s Guide |
| |
|
|
|