Ending your RealView Debugger Session

5.1.4Settings options

By default, RealView Debugger writes your current settings to your startup file ready for re-use, saves your current workspace, and reloads this workspace at the next start-up.

To change these defaults, select File Workspace from the main menu to display the Workspace menu shown in Figure 5-1 on page 5-2.

At the bottom of this menu are your current settings options. Enable or disable the required options to decide how your next RealView Debugger session starts. For example, if Same Workspace on Startup is unselected, RealView Debugger does not use the current workspace at the next start-up. This means that, unless another workspace is specified on the command line, RealView Debugger opens the default workspace.

These options are saved in your startup file when you exit RealView Debugger.

5-4

Copyright © 2002 ARM Limited. All rights reserved.

ARM DUI 0181B

Page 82
Image 82
ARM Version 1.6 manual Settings options