Bose MR-J2S- B instruction manual MR-J2S-500B

1. FUNCTIONS AND CONFIGURATION

(3) MR-J2S-500B

POINT

The servo amplifier is shown without the front cover. For removal of the front cover, refer to Section 1.7.2.

	6	7		8	9
5						A
						B
4							C
3
2						E	D
	1		0 F

Installation notch (4 places)

Cooling fan

Name/Application

Battery connector (CON1)

Used to connect the battery for absolute position data backup.

Battery holder

Contains the battery for absolute position data backup.

Display

The two-digit, seven-segment LED shows the servo status and alarm number.

Axis select switch (CS1)

CS1

7	8	9		Used to set the axis number of the
5			B	servo amplifier.
4			C
3			D
1	0	F

Bus cable connector (CN1A)

Used to connect the servo system controller or preceding axis servo amplifier.

Bus cable connector (CN1B)

Used to connect the subsequent axis servo amplifier or termination connector (MR-A-TM).

Communication connector (CN3)

Used to connect a personal computer (RS-232C) or output analog monitor data.

Encoder connector (CN2)

Connector for connection of the servo motor encoder.

Charge lamp

Lit to indicate that the main circuit is charged. While this lamp is lit, do not reconnect the cables.

Control circuit terminal block (TE2)

Used to connect the control circuit power supply.

Main circuit terminal block (TE1)

Used to connect the input power supply, regenerative brake option and servo motor.

Name plate

Protective earth (PE) terminal ()

Ground terminal.

Refer to

Section13.3

Section13.3

Chapter4

Section3.11

Section3.2

Section3.2

Section3.2

Section12.1.4

Section3.2

Section12.1.4

Section3.5.2

Section10.1

Section12.1.1

Section3.5.2

Section10.1

Section1.5

Section3.8

Section10.1

1 - 9