Bose MR-J2S- B instruction manual Approx mm

3. SIGNALS AND WIRING

3.9 Servo amplifier terminal block (TE2) wiring method

(1)Termination of the cables

Solid wire: After the sheath has been stripped, the cable can be used as it is. (Cable size: 0.2 to 2.5mm2)

Approx. 10mm

Twisted wire: Use the cable after stripping the sheath and twisting the core. At this time, take care to avoid a short caused by the loose wires of the core and the adjacent pole. Do not solder the core as it may cause a contact fault. (Cable size: 0.2 to 2.5mm2)Alternatively, a bar terminal may be used to put the wires together.(Phoenix contact)

Bar terminal for 1 cable	Bar terminal for 2 cable
(Bar terminal ferrule with insulation sleeve)	(Twin ferrule with insulation sleeve)

Cable size			Bar terminal type		Crimping
[mm2]	AWG	For 1 cable	For 2 cables		tool
0.25	24	Al0.25-6YE
		Al0.25-8YE
0.5	20	Al0.5-6WH
		Al0.5-8WH
0.75	18	Al0.75-6GY	Al-TWIN2	0.75-8GY
		Al0.75-8GY	Al-TWIN2	0.75-10GY
					CRIMPFOX-UD6
		Al1-6RD	Al-TWIN2	1-8RD
1	18
		Al1-8RD	Al-TWIN2 1-10RD
1.5	16	Al1.5-6BK	Al-TWIN2	1.5-8BK
		Al1.5-8BK	Al-TWIN2 1.5-12BK
2.5	14	Al2.5-8BU	Al-TWIN2	2.5-10BU
		Al2.5-8BU-1000	Al-TWIN2	2.5-13BU

3 - 23