Bose MR-J2S- B instruction manual MR-J2S-200B MR-J2S-350B

1. FUNCTIONS AND CONFIGURATION

(2) MR-J2S-200B MR-J2S-350B

POINT

The servo amplifier is shown without the front cover. For removal of the front cover, refer to Section 1.7.2.

Cooling fan

Installation notch (4 places)

7

5 4

3 2

1 0

8	9	A
		B
			C
		E	D
F

				Name/Application	Refer to
Battery holder					Section13.3
Contains the battery for absolute position data backup.
Battery connector (CON1)					Section13.3
Used to connect the battery for absolute position data
backup.
Display					Chapter4
The two-digit, seven-segment LED shows the servo
status and alarm number.
Axis select switch (CS1)
CS1
7	8	9		Used to set the axis number of
5			B	the servo amplifier.
4			C
3			D
1	0	F
					Section3.11

Bus cable connector (CN1A)
Used to connect the servo system controller or		Section3.2
preceding axis servo amplifier.
Bus cable connector (CN1B)
Used to connect the subsequent axis servo amplifier		Section3.2
or termination connector (MR-A-TM).
Communication connector (CN3)		Section3.2
Used to connect a personal computer (RS-232C) or
		Section12.1.4
output analog monitor data.
Name plate		Section1.5
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)		Section3.2
Connector for connection of the servo motor encoder. Section12.1.4
Main circuit terminal block (TE1)		Section3.5.2
Used to connect the input power supply and servo
		Section10.1
motor.
Control circuit terminal block (TE2)		Section3.5.2
Used to connect the control circuit power supply and		Section10.1
regenerative brake option.		Section12.1.1
Protective earth (PE) terminal (	)	Section3.8
Ground terminal.		Section10.1

1 - 8