Bose MR-J2S- B instruction manual Connection of the regenerative brake option

12.OPTIONS AND AUXILIARY EQUIPMENT

(4)Connection of the regenerative brake option

The regenerative brake option will generate heat of about 100. Fully examine heat dissipation, installation position, used cables, etc. before installing the option. For wiring, use flame-resistant cables and keep them clear of the regenerative brake option body. Always use twisted cables of max. 5m(16.4ft) length for connection with the servo amplifier.

(a)MR-J2S-350B or less

Always remove the wiring from across P-D and fit the regenerative brake option across P-C.

Servo amplifier

D

P

C

Always remove the lead from across P-D.

Regenerative brake option

P

C

G3 (Note) G4

5m (16.4 ft) max.

G3 G4: Thermal protector terminals. Abnormal heating will dis- connect G3-G4.

Note: Make up a sequence which will switch off the magnetic contactor (MC) when abnormal heating occurs.

(b)MR-J2S-500B MR-J2S-700B

Always remove the wiring (across P-C) of the servo amplifier built-in regenerative brake resistor and fit the regenerative brake option across P-C.

Servo amplifier

P

C

Always remove wiring (across P-C) of servo amplifier built-in regenerative brake resistor.

Regenerative brake option

P

C

G3 (Note 2) G4

5m(16.4ft) or less		G3	G4: Thermal protector terminals.
			Abnormal heating will dis-
	Fan (Note 1)		connect G3-G4.

Note 1. When using the MR-RB51, forcibly cool it with a cooling fan (1.0m3/min, 92 or so).

2.Make up a sequence which will switch off the magnetic contactor (MC) when abnormal heating occurs.

12 - 4