Bose MR-J2S- B instruction manual 2Configuration, 3Operation procedure, Operation And Display

4. OPERATION AND DISPLAY

(2)Configuration

Configuration should be as in Section 3.1. Always install a forced stop switch to enable a stop at occurrence of an alarm.

(3)Operation procedure

(a)Jog operation, positioning operation, program operation, DO forced output.

1)Switch power off.

2)Set CS1 to “F”.

When CS1 is set to the axis number and operation is performed by the servo system controller, the test operation mode screen is displayed on the personal computer, but no function is performed.

3)Switch servo amplifier power on.

When initialization is over, the display shows the following screen:

Decimal point flickers.

4)Perform operation with the personal computer.

(b)Motor-less operation

1)Switch off the servo amplifier.

2)Perform motor-less operation with the personal computer. The display shows the following screen:

Decimal point flickers.

4 - 8