Bose MR-J2S- B instruction manual Ex A.2003

12.OPTIONS AND AUXILIARY EQUIPMENT

(b)Surge suppressor

The recommended surge suppressor for installation to an AC relay, AC valve, AC electromagnetic brake or the like near the servo amplifier is shown below. Use this product or equivalent.

MS

Surge suppressor

Surge suppressor

Rated
voltage	C [ F]	R [ ]	Test voltage AC[V]
AC[V]
200	0.5	50	Across
		(1W)	T-C 1000(1 to 5s)

Relay

Surge suppressor

This distance should be short (within 20cm(0.79 in.)).

(Ex.) 972A.2003 50411

(Matsuo Electric Co.,Ltd. 200VAC rating)

		Outline drawing [Unit: mm] ([Unit: in.])
				Vinyl sheath						18	1.5
	Blue vinyl cord						Red vinyl cord			(0.71	0.06)
										6(0.24)
		10(0.39)or less			10(0.39)or less					4(0.16)
10	3		15	1(0.59		0.04)		10	3	31(1.22)
(0.39								(0.39
0.12)		200(7.87)		48	1.5		200(7.87)	0.15)
		or more	(1.89		0.06)		or more

Note that a diode should be installed to a DC relay, DC valve or the like.

Maximum voltage: Not less than 4 times the drive voltage of the relay or the like

Maximum current: Not less than twice the drive current of

the relay or the like

RA

Diode

(c) Cable clamp fitting (AERSBAN -SET)

Generally, the earth of the shielded cable may only be connected to the connector's SD terminal. However, the effect can be increased by directly connecting the cable to an earth plate as shown below.

Install the earth plate near the servo amplifier for the encoder cable. Peel part of the cable sheath to expose the external conductor, and press that part against the earth plate with the cable clamp. If the cable is thin, clamp several cables in a bunch.

The clamp comes as a set with the earth plate.

Strip the cable sheath of
the clamped area.	cutter
	cable

	Cable
Cable clamp		Earth plate
(A,B)

40(1.57)

External conductor

Clamp section diagram

12 - 30