Bose MR-J2S- B Indication list, Operation And Display, 2.** indicates the warning/alarm No

4. OPERATION AND DISPLAY

(2) Indication list

Indication		Status			Description
	AA	Initializing	The servo amplifier was switched on when power to the servo system
			controller is off.
			Power to the servo system controller was switched off during power-on of
			the servo amplifier.
			The axis No. set to the servo system controller does not match the axis No.
	Ab	Initializing	set with the axis setting switch (CS1) of the servo amplifier.
			A servo amplifier fault occurred or an error took place in communication
			with the servo system controller. In this case, the indication changes:
			"Ab" "AC"	"Ad"	"Ab"
			The servo system controller is faulty.
	AC	Initializing	Communication	started	between the servo system controller and	servo
			amplifier.
	Ad	Initializing	The initial parameters from the servo system controller were received.
	AE	Initialize completion	Initial data communication with the servo system controller was completed.
(Note 1)	b#	Ready OFF	The ready off signal from the servo system controller was received.
(Note 1)	d#	Servo ON	The ready off signal from the servo system controller was received.
(Note 1)	C#	Servo OFF	The ready off signal from the servo system controller was received.
(Note 2)	**	Alarm Warning	The alarm No./warning No. that occurred is displayed. (Refer to Section 9.1.)
	88	CPU error
(Note 3)	b0.		JOG operation,	positioning operation, programmed operation, DO		forced
			output.
		(Note 3)
(Note 1)	b#.
		Test operation mode
	d#.		Motor-less operation
	c#.

Note: 1. # denotes any of numerals 0 to 8 and what it means is listed below:

#	Description
0	Set to the test operation mode.
1	First axis
2	Second axis
3	Third axis
4	Fourth axis
5	Fifth axis
6	Sixth axis
7	Seventh axis
8	Eighth axis

2.** indicates the warning/alarm No.

3.Requires the servo configuration software.

4 - 5