Emerson Process Management 5300 manual Errors, Normally result in Analog Output alarm

Rosemount 5300 Series

Reference Manual

00809-0100-4530, Rev BA July 2009

Errors	Error messages that may be displayed on the Integral Display, on a 375
	Handheld Communicator, in AMS, or in RRM are shown in Table 7-5.Errors
	normally result in Analog Output alarm.
	Errors are indicated in RRM in the Diagnostics window.

Table 7-5. Error messages.

Message	Description		Action
RAM error	An error in the gauge data memory	Contact Emerson Process
	(RAM) has been detected during the	Management Service Department.
	startup tests. Note: this automatically
	resets the gauge.
FPROM error	An error in the gauge program	Contact Emerson Process
	memory (FPROM) has been detected	Management Service Department.
	during the startup tests. Note: this
	automatically resets the gauge.
Database (Hreg) error	An error in the transmitter	Load default database and restart the
	configuration memory (EEPROM) has	transmitter. Contact Emerson
	been detected. The error is either a	Process Management Service
	checksum error that can be solved by	Department if the problem persists.
	loading the default database or a
	hardware error.
	NOTE: the default values are used
	until the problem is solved.
Microwave Module error	An error in the microwave module.	Contact Emerson Process
		Management Service Department.
LCD error	An error in the LCD is detected.	Contact Emerson Process
		Management Service Department.
Modem error	An error in the modem used for digital	Contact Emerson Process
	communication has been detected.	Management Service Department.
Analog out error	An error in the Analog Out Module.	Contact Emerson Process
		Management Service Department.
Internal temperature error	An error in the internal temperature	Contact Emerson Process
	measurement.	Management Service Department.
	-40 ºC<Internal Temperature<85 ºC.
Other hardware error	An unspecified hardware error has	Contact Emerson Process
	been detected.	Management Service Department.
Measurement error	A serious measurement error has	Contact Emerson Process
	been detected.	Management Service Department.
Configuration error	At least one configuration parameter	•	Load the default database and
	is outside allowed range.		restart the transmitter (see “Reset
	NOTE: the default values are used		to Factory Settings” on page 7-22)
	until the problem is solved.	•	Configure the transmitter or upload
			a backup configuration file (see
			“Backing up the Transmitter
			Configuration” on page 7-20)
		• Contact Emerson Process
			Management Service Department if
			the problem persists
Software error	An error has been detected in the	Contact Emerson Process
	transmitter software.	Management Service Department.

7-36