Emerson Process Management 5300 Analog Input AI Function Block, Transducer Block Xderr messages

Reference Manual

00809-0100-4530, Rev BA July 2009

Rosemount 5300 Series

Transducer Block

Table 7-16. Transducer Block BLOCK_ERR messages

This section describes error conditions found in the Sensor Transducer Block.

Condition Name and Description

Other

Out of Service: The actual mode is out of service

Table 7-17. Transducer Block XD_ERR messages

Condition Name and Description

Electronics Failure: An electrical component failed

I/O Failure: An I/O failure occurred

Data Integrity Error: Data stored in the device is no longer valid due to a non-volatile memory checksum failure, a data verify after write failure, etc.

Algorithm Error: The algorithm used in the transducer block produced an error due to overflow, data reasonableness failure, etc.

Analog Input (AI) Function Block

Table 7-18. AI BLOCK_ERR Conditions

This section describes error conditions that are supported by the AI Block. Read Table 7-19to determine the appropriate corrective action.

.

Condition	Condition Name and Description
Number
0	Other
1	Block Configuration Error: the selected channel carries a measurement that
	is incompatible with the engineering units selected in XD_SCALE, the L_TYPE
	parameter is not configured, or CHANNEL = zero
3	Simulate Active: Simulation is enabled and the block is using a simulated
	value in its execution
7	Input Failure/Process Variable has Bad Status: The hardware is bad, or a
	bad status is being simulated
14	Power Up
15	Out of Service: The actual mode is out of service

7-45