Emerson Process Management 5300 manual Analog Output Status

Reference Manual

00809-0100-4530, Rev BA July 2009

Rosemount 5300 Series

Analog Output Status		Analog Output Status messages that may appear on the Integral Display, on
		the 375 Handheld Communicator, or in RRM are shown in Table 7-10:
Table 7-10. Analog Output
status.
	Message		Description	Action
	Not connected		Analog output hardware is not
			connected.
	Alarm Mode		The analog output is in Alarm Mode.	Check Error and Warning Messages
				to find the reason for the Alarm.
	Saturated		The analog output signal value is	No action needed.
			saturated, i.e. equal to the saturation
			value.
	Multidrop		The transmitter is in Multidrop Mode.	This is the normal setting when a
			The analog output is fixed at 4 mA.	device is used in Multidrop
				configuration.
	Fixed Current mode		The analog output is in fixed current	This mode is used when calibrating
			mode.	the Analog Output channel.
	PV out of Limits		The Primary variable is out of range.	Check the Upper and Lower Range
				Value
	Span Too Small		The configured span is too small.	Check the Upper and Lower Range
				Value.
	Invalid Limits		The given Upper and Lower Sensor	Check that the difference between the
			Limits are invalid.	Upper and Lower Sensor Limits is
				greater than the Minimum Span.

7-41