Emerson Process Management 5300 manual Mount the probe housing on the probe

Rosemount 5300 Series

Reference Manual

00809-0100-4530, Rev BA July 2009

M6 screw

		Mount the bracket to the pole
		Mount the bracket to the pole, making sure the
		distance between the probe and bracket does
		not exceed the length of the remote connection.
		1.	Put the two U-bolts through the holes of
			the bracket. Several holes are available for
			vertical/horizontal pipe mounting.
		2.	Put the clamping brackets on the U-bolts
			and around the pipe.
U-bolt	Bracket Clamping Brackets	3.	Use the supplied nuts to fasten the bracket
			to the pipe.

Fasten the housing support to the bracket

Fasten the housing support to the bracket using the M6 screws. The screws are threaded through the top of the mounting bracket and into the housing support.

Mount the probe housing on the probe

Mount the probe housing on the probe, making sure that the M50 nut is properly tightened.

M50 nut

Connect the transmitter head on the housing support

Connect the transmitter head on the housing support, making sure that the M50 nut is properly tightened.

See “Remote Housing Configuration” on page D-4to check if the transmitter is configured with remote housing.

D-2