Emerson Process Management 5300 LCD Error Messages, For more information on errors, see Errors on

Rosemount 5300 Series

Reference Manual

00809-0100-4530, Rev BA July 2009

LCD ERROR MESSAGES

Figure 7-24. The 5300 Display Panel displaying an error message.

Table 7-11. Error messages displayed on the 5300 Display Panel.

Error Message

Error Message	Description
	An error in the gauge data memory (RAM) has been
RAM FAIL	detected during the startup tests. Note: this resets the
	gauge automatically.
FPROM FAIL	An error in the gauge program memory (FPROM) has
	been detected during the startup tests. Note: this
	resets the gauge automatically.
	An error in the transmitter configuration memory
	(EEPROM) has been detected. The error is either a
HREG FAIL	checksum error that can be solved by loading the
	default database, or a hardware error.
	NOTE: the default values are used until the problem is
	solved.
OMEM FAIL
MWM FAIL	An error in the microwave module.
DPLY FAIL	An error in the LCD.
MODEM FAIL	Modem hardware failure.
AOUT FAIL	An error in the Analog Out Module.
OHW FAIL	An unspecified hardware error has been detected.
ITEMP FAIL	An error in the internal temperature measurement.
MEAS FAIL	A serious measurement error has been detected.
	At least one configuration parameter is outside the
CONFIG FAIL	allowed range.
	NOTE: the default values are used until the problem is
	solved.
SW FAIL	An error has been detected in the transmitter software.

For more information on errors, see “Errors” on page 7-36.

7-42