Emerson Process Management manual Rosemount 5300 Series

Reference Manual

00809-0100-4530, Rev BA July 2009

Rosemount 5300 Series

Message	Description	Action
Sim mode 0 active	The simulation mode is active. The given	Turn off the simulation mode.
	measurements are simulated.
Advanced Simulation Mode	The advanced simulation mode is active.	To turn off the Advanced Simulation
active		mode, set Holding Register 3600=0 (see
		“Viewing Input and Holding Registers” on
		page 7-27).
Invalid Lower Volume Value	The given lower volume value is invalid.	Check Lower Volume Status for details.
Invalid Upper Volume Value	The given upper volume value is invalid.	Check Upper Volume Status for details.
Using probe end projection	The probe end projection is active in the	No action needed.
measurement	transmitter software.
Reference echo present	An echo has been detected in the	No action needed.
	reference zone.
Sudden level jump detected	This may result from various	Check the tank to find out what causes
	measurement problems, such as:	problem to track the surface.
	1. Rapid level changes	1. Set the Rapid Level Changes
	2. Surface level within transition zone	parameter, see “Tank Environment” on
	3. Disturbing echo	page 5-6.
		2. In the Transition Zones, the level may
		jump to Full Tank/End of Probe, see
		“Transition Zones” on page 2-10.
		3. See “Disturbance Echo Handling” on
		page 7-7.
Nearzone echo present	An echo has been detected in the	No action needed.
	nearzone.
Nonlinear gain used	The nonlinear gain is enabled.	No action needed.
Nearzone measurement	The current sweep can be used as a	No action needed.
	measurement of the nearzone.

7-39