Emerson Process Management 5300 manual Amplitudethresholdcurve

Rosemount 5300 Series

Reference Manual

00809-0100-4530, Rev BA July 2009

Parameter	Index	Description
	Number
AMPLITUDE_THRESHOLD_CURVE	13	ATC: filters out weak disturbance echoes and noise.
SIMULATION_MODE	14	Simulation of measurement values.
SET_CONSTANT_THRESHOLD	15	A constant amplitude threshold can be used to filter out noise.
RADAR_LEVEL_RANGE	16
RADAR_LEVEL_SIGNAL_STRENGT	17
H_RANGE
RADAR_VOLUME_RANGE	18
ENV_PRESENTATION	19
PROBE_END_THRESH	20	This threshold is used to locate the probe end echo. The probe
		end echo is used by the device to know when the tank is empty,
		but is sometimes also useful when no surface echo can be found.
REFERENCE_THRESH	21	This threshold is used to locate the reference echo.
INTERFACE_THRESH	22	This threshold is used to block out disturbing echoes and noise
		when locating the interface echo.
FULL_TANK_THRESH_OFFSET	23	By adding an offset to the Reference Threshold it is possible for
		the device to determine when the tank is full. If the reference echo
		amplitude is between the Reference Threshold and the Full Tank
		Threshold then the tank is considered full.
PEP_PRODUCT_DC	24	Enter the product dielectric constant for the product in the tank.
AUTO_CONF_MEAS_FUNC	25
ECHO_TIME_OUT	26	Change this parameter to define the time in seconds before the
		device should start to search for a surface echo after it has been
		lost.
CLOSE_DIST	27	This parameter defines a window centered at the current surface
		position where new surface echo candidates can be selected. The
		size of the window is +/-Close Distance. Echoes outside this
		window will not be considered as surface echoes.
USED_PROBE_END_THRESH	28	Probe End Threshold currently used in the device.
USED_REFERENCE_THRESH	29	Reference Threshold currently used in the device.
USED_INTERFACE_THRESH	30	Interface Threshold currently used in the device.
USED_TANK_PRESENTATION	31
USED_ECHO_TIME_OUT	32	Echo Timeout currently used in the device.
USED_CLOSE_DIST	33	Close Distance currently used in the device.
SW_SUPPORT2	34	Defines what options are enabled in the device.
USED_HOLD_OFF_DIST	35	The upper null zone distance currently used in the device.
USED_PEP_PRODUCT_DC	36	Product Dielectric currently used in the device.
START_CODE	37	This code determines what options are available in your device.
		Do not change your Start Code unless you have received a valid
		one. Use Enter Start Codes method to change it.
UNIT_CODE	38	Unit code 1 -4 can be sent to your local Emerson representative in
		order to receive new Start Codes for upgrading your device.
ENV_SET_START_CODE	39	Set Start Code
PROBE_END_ANCHORING	40
PEP_PROBE_END_OFFSET	41
USED_PEP_ PROBE_END_OFFSET	42
VOL_VOLUME_CALC_METHOD	43	Choose what kind of volume calculation method to use.
VOL_IDEAL_DIAMETER	44	Diameter of the tank (only for ideal tank shapes).
VOL_IDEAL_LENGTH	45	Length/height of the tank (only for ideal tank shapes).

H-2