Emerson Process Management 5300 manual Table F-3. Probe Type, Maxupperproductthickness

Reference Manual

00809-0100-4530, Rev BA July 2009

Rosemount 5300 Series

Parameter	Index Number	Description
STATS_TIMEOUTS	71	The total number of timed out A/D board message attempts
MAX_UPPER_PRODUCT_THICKNESS	72	This is the maximum thickness of the upper product that the
		device is able to measure through. If the thickness of the
		upper product is larger than this value, the device will not be
		able to locate the interface echo
MEAS_STATUS	73
INTERFACE_STATUS	74
REMOTE_HOUSING	75
MEAS_VAPOR_DC	76	Measured Vapor Dielectric Constant
SPEC_CONFIG_TNZ	77	Configure Trim Near Zone
SPEC_CONFIG_PEP	78	Configure Probe End Projection
SPEC_CONFIG_TANK_MATERIAL	79	Configure Tank Material
SPEC_CONFIG_VC	80	Configure Vapor Compensation
VC_WARNING	81	Vapor Compensation Warning
PEP_STATUS	82	Probe End Projection Status
TANK_MATERIAL	83
SW_SUPPORT2	84	Defines what options are enabled in the device.
MOUNTING_TYPE	85
PIPE_DIAMETER	86
NOZZLE_HEIGHT	87
DEVICE_HW_CONFIG	88
DEVICE_STATUS	89
VOLUME_STATUS	90
MWM_WARNING	91
MEAS_WARNING	92
CONFIG_WARNING	93
VAPOR_COMP_STATUS	94	Vapor Compensation Status

Table F-3. Probe Type

VALUE	PROBE_TYPE
0	User defined
1	Rigid Twin
2	Flexible Twin
3	Coaxial
4	Rigid Single 0.3 in. (8 mm)
5	Flexible Single
10	Coaxial HTHP
11	Coaxial HP/C
12	Rigid Single HTHP/HP 0.3 in. (8 mm)
13	Flexible Single HTHP
20	Rigid Single PTFE
21	Flexible Single PTFE
30	Rigid Single HP/C 0.3 in. (8 mm)
31	Flexible Single HP
32	Flexible Single PA
33	Rigid Single 0.5 in. (13 mm)
40	Rigid Single HTHP 0.5 in. (13 mm)
41	Rigid Single HP/C 0.5 in. (13 mm)

F-5