User and Installation Guide
9.Slide the mast clamp down onto the mast. Make sure that the pivot bolt rests on the top of the mast.
Tighten the elevation bolts and the pivot bolt so that the bracket is snug, but can still be moved up and down.
10.Turn the antenna mount on the mast or pole to align the LNBF support arm in the direction of the satellites. Use the direction you found earlier using the Point Dish and Signal Strength menu.
Tighten the mast clamp bolts so that the clamp is snug, but can still be moved back and forth.
Pivot
Bolt
Elevation Bolts
(one on each side)
Mast Clamp
Bolts
You may have either one or two LNBF cables to attach, depending on which type of LNBF you purchased: single or dual output.
Note: If you have to attach two cables to the LNBF, the following instructions apply to both cables. Use only
Page
